ComfortCostGuide

Metro cost guide

Killeen, Texas: HVAC Replacement Cost Calculator

Replacing an HVAC system in Killeen typically runs $4,000 to $7,500 for a straight central air conditioner, $6,000 to $12,000 for a heat pump, and $7,500 to $13,000 for a matched AC and gas furnace pair. Labor here runs about 9% below the national average, with local HVAC technicians earning around $28.43 an hour, which keeps installed pricing a bit friendlier than in larger Texas metros. Budget another $75 to $300 for the mechanical permit on top of the equipment and labor quote.

Worked example

Take a 1,900 sq ft single-story house off Stan Schlueter Loop with an original 15-year-old split system. The homeowner replaces the condenser, coil, and gas furnace as a matched pair, reusing the existing ductwork and pad. With no duct rework and a standard-efficiency system, that job lands in the lower-middle of the $7,500 to $13,000 AC-plus-furnace range, roughly $9,000 to $10,000 installed, plus a permit fee between $75 and $300. Stepping up to a higher-efficiency variable-speed system or adding duct sealing pushes the same house toward the top of the range.

Frequently asked questions

How much does it cost to replace just the AC in Killeen?

A central air conditioner replacement in Killeen generally costs $4,000 to $7,500 installed, covering equipment and labor. Straightforward swaps that reuse existing ductwork and electrical fall near the low end, while higher-efficiency units, larger tonnage, or added line-set and coil work move you toward $7,500.

Is a heat pump a good choice in Killeen's climate?

Killeen sits in climate zone 2, where winters are mild and cooling dominates the year, so a heat pump can handle both heating and cooling from a single system. Heat pumps run $6,000 to $12,000 installed here, compared with $7,500 to $13,000 for a separate AC and gas furnace pair, so the all-electric route is often competitive on both upfront cost and long-term simplicity.

Do I need a permit to replace my HVAC system in Killeen?

Yes, mechanical permits are required for HVAC replacements, and in the Killeen area they typically run $75 to $300. Your contractor normally pulls the permit and folds the fee into the quote, so ask whether it is included before you sign.

How do I verify an HVAC contractor is licensed in Killeen?

Texas requires HVAC contractors to hold a TACLA or TACLB license issued by the Texas Department of Licensing and Regulation. Ask for the license number and confirm it through TDLR before work begins, along with proof of insurance.

Are there rebates for a new HVAC system near Killeen?

Two programs to check are Austin Energy's home HVAC rebates and Oncor's residential HVAC incentives, both of which vary by system type and efficiency level. Oncor incentives are handled through participating contractors, so confirm your installer is enrolled before the job is scheduled, and verify your address is served by the utility offering the rebate.

Related cost guides